Working with riflescopes seems pretty straightforward, and in most cases, it is. However, there are a few little shortcuts that can make it easier to work with your optic and stay on target at extended ranges: TIP—Which way to turn Fortunately, most riflescope turrets have indication marks telling you which way to turn them. But sometimes these marks can be worn, or you might have to change your position behind the rifle to see them. In those instances, there’s a simple rule of thumb to help you remember which way to turn.

For the windage turret you push forward with your thumb—clockwise—to go left (push left) and pull toward you—counterclockwise—to go right (pull right). With the elevation turret you push—clockwise—to go down (push down) and pull—counterclockwise—to go up (pull up.)

TIP—Zero confirmation Many hunters zero their rifles at extended distance to maximize their point-blank range. But, when they arrive at camp and want to check their zero, they may only have a 50-yd. range to work with. To simplify the process, after zeroing your rifle at distance, shoot a target at 50 yds. and then fold the target up and place it in your rifle case. When you get to your hunting destination simply put that target up at 50 yds. and shoot it to confirm that your zero has not wandered. If you do not hit the same hole, adjust and reconfirm accordingly.

To apply this reticle in the field, let’s assume your bullet drops 12" at 300 yds. and that the gap measurement mentioned above equals 4" at 100 yds. To compensate for the trajectory of your bullet you would simply hold the bottom taper point of the center crosshair dead-on at that distance. Similarly, if you’re also shooting in a 10-m.p.h. crosswind at 300 yds. and your bullet deflects 6" at that distance, you would also want to hold half of that gap into the wind.

Where this technique gets complicated, but can be even more effective, is with a second-focal-plane riflescope. This is because the gap measurement changes with the magnification. If that gap measures 4" at 6X, it will measure 2" at 12X. This can allow you to adjust the gap size—the hold-over or wind correction—by adjusting the magnification.

It takes some practice on the range to become proficient with this technique, but it works. The best way to apply the technique with a second-focal-plane riflescope is to confirm and then remember the magnification setting for the distances you might shoot at in advance. If you know you need 20" of correction to hit at 400 yds., work with your scope on the range to determine what magnification adjusts this gap measurement to equal 20". 

There are few places in the country more impressive than The Cody Firearms Museum for history buffs and firearms enthusiasts, and Henry Repeating Arms, Baron Engraving and Davidson’s have created something special to support the facility.

As of this writing, the people of Ukraine are locked in a life-and-death struggle with the invading Russian military in the most significant warfare seen in Europe since World War II.

By the latter part of the 1830s, most of the major powers finally let practicality overcome economy, realizing that it was time to switch their small arms over from flintlock to percussion. Britain and France were among the earliest, with the United States following suit in short order—the Americans fielding the handsome Model of 1842.

Externally configured as a standard vertical fore-grip, the B&T Unigrip QD With Bipod Foldable, as its name suggests, also features a throw-lever Picatinny-rail attachment clamp and more.

Read today's "The Armed Citizen" entry for real stories of law-abiding citizens, past and present, who used their firearms to save lives.

Now in their 20th year, the Golden Bullseye Awards are chosen annually to recognize the firearm industry’s best new offerings. Here is this year’s winners as selected by the editors of “The World’s Oldest And Largest Firearm Authority.”